ELEGOO Motherboard for Centauri Carbon

The factory control board for the Centauri Carbon. Everything runs through it — axis and extruder steppers, hotend and bed heating, sensor readouts. You replace the whole board when the printer stops seeing a motor or a heater while the wiring and the parts themselves check out fine: a blown driver or MOSFET isn't a component you swap on your bench. The drivers sit under a shared heatsink and mains-side power lands on screw terminals.

Specifications

• Genuine ELEGOO board, drop-in replacement for the stock one
• Drives axis and extruder motors, hotend and bed heaters
• Heatsinked stepper drivers, screw-terminal power input
• Touchscreen ribbon header and onboard USB-A port

Compatibility: ELEGOO Centauri Carbon. The Centauri 2 and Centauri Carbon 2 use their own board — generations aren't interchangeable, so check your model first.