ELEGOO Mini Heater for Resin 3D Printers

A chamber heater for resin printing. Cold resin turns thick, drains badly off the model and tears layers apart — this module holds the chamber at working temperature so a print in an unheated garage stops being a coin flip. 120 W of PTC heating gets there fast, and the built-in sensor kicks in below 25 °C and shuts off once it's warm again. The current reading sits on the front display.

Specifications

• 120 W rated power, PTC heating element
• 100–240 V, 50/60 Hz input; 24 V / 5 A brick output
• 59 × 71 × 132 mm body, 40.5 × 40.5 × 23 mm filter
• Thermostat: heats below 25 °C, cuts out at 25 °C

Compatibility: enclosed ELEGOO resin printers — the Mars and Saturn lines. It bolts to an adapter plate that screws onto the printer shell, so any other brand with room inside the chamber works too.