Extruder Control Board for ELEGOO Centauri Carbon

A two-piece print head electronics set for the Centauri Carbon: the main board with an ARM controller and a USB-C port, plus the small heater board carrying the thermistor. The main board drives the extruder motor, the fans and the sensors, and talks to the mainboard over a single cable. Swap it when the head stops responding, a sensor reads garbage or the heater connector burns.

Specifications

• Two boards in the kit: main EF-I1 board and heater board with thermistor
• ARM controller with a USB-C port for head firmware updates
• Connectors for extruder motor, fans, heater and sensors
• Genuine ELEGOO part, installs in the stock position as-is

Compatibility: ELEGOO Centauri Carbon (CC1). The Centauri Carbon 2 uses its own board revision, so check the marking on the board you pulled before ordering.