ELEGOO PFA Release Film for Mars 3 & Mars 3 Pro (5 Pcs)

A five-pack of vat films for the Mars 3 and Mars 3 Pro. You swap the film when a milky patch shows up where the UV hits hardest, or when parts start sticking to the vat floor instead of the plate. PFA beats FEP on heat tolerance and releases more softly — less suction on each layer means fewer prints torn off the plate and fewer supports left behind. Rated at up to 9,000 peel cycles.

Specifications

• 5 sheets per pack, 146 × 195 mm each
• 0.127 mm thick, 95% light transmittance
• Up to 9,000 peels — about 50% more than standard film
• Wear and chemical resistant, no wrinkles or bubbles

Compatibility: ELEGOO Mars 3 and Mars 3 Pro, 143 × 89.6 mm build area. Peel the protective layer off both sides before fitting — leave it on and no UV gets through.