Description
Two H1 HT dryers in one order. The logic is simple: each box holds a single spool, and a two-material print — nylon for the model, PVA for the supports — needs both filaments dried at the same time. Two units sit beside the printer and feed it directly, no swapping spools between cycles. The pair costs $10 less than two units bought separately.
Specifications
- Two H1 HT dryers, each holding one 1.75 mm spool
- 45–85 °C heating, 0.5–12 hour timer, 11 material presets from PLA to PAHT-CF and PVA
- Rotating drying with active dehumidification — filament stays print-ready up to 10 days at 25 °C, 60% RH
- Each box has its own 3.5-inch touchscreen and lid-open detection; 280 × 256 × 126 mm, 150 W at 220 V
Compatibility: universal — works with any brand of printer. The two-pack isn't listed on AliExpress and ELEGOO doesn't sell single H1 HT units there either, so only the official link is shown.